DIY: LED Workbench Light From LED Strips

In this video I’ll show you how to make simple workbench light by using high CRI Yuji LED strips and piece of aluminum.

Yuji LED online store: http://store.yujiintl.com

My used LED strip from Yuji LED: http://store.yujiintl.com/collections/high-cri-led-strips-ribbon/products/bc-series-ribbon-120led-2835?variant=3100847937

Flicker free power supply from Yuji LED: http://store.yujiintl.com/products/flicker-free-dimmable-power-supply-for-high-cri-led-strip-unit-1-pcs?variant=14066347015

Support Well Done Tips on Patreon:
https://www.patreon.com/welldonetips

Due to factors beyond the control of WellDoneTips, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. WellDoneTips assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. WellDoneTips recommends safe practices when working with the tools or equipment seen or implied in this video. Due to factors beyond the control of WellDoneTips, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not WellDoneTips.

Comments

Carl Zorro says:

I hope you’re one of the ones going to mars, with your tech stuff 🙂

Carl Zorro says:

would have been cheaper putting a house lamp, with no shade poof the whole room be like a Hollywood spot light 🙂

Stavros Gakos says:

nice idea!

Carl Zorro says:

have hit your forehead yet or hooked your neck with it? lol

DIY Jury says:

simple and useful

Joy Stolz says:

that’s really dumm jes?

Vedran Latin says:

Nice project I think it’s missing just one detail.
LED strips can have quite a bit of resistance in the traces so the voltage drops somewhat as you move further away from the supply wires, resulting in an uneven amount of light and heat if you power a full 5m strip from just one side. Since you’re only using 2.5m it’s probably less noticeable, but you can easily compensate by moving one supply wire (doesn’t matter which one) to the other strip. That way +12V is connected to the one end of the combined strip and ground at the other. Since losses in both rails are equal but now increase in opposite directions, all segments will see the same voltage. Alternatively, you could power both strips directly from the supply wires and not daisy chain them thus reducing the length on the strip and losses. You could even combine both methods and use the aluminum strip as a common ground.

MrJetpaul says:

well done! 🙂

Thomas Wepfer says:

nice

John Doe says:

Cool Idea

petr mertl says:

Cool

Corey Gibson says:

​Thanks. I’ve been wanted to make some video lights after I found my LED lights in the basement were flickering in video. I knew I would have to look for some kind of a flicker free PSU but wasn’t even sure where to start. I wasn’t aware of the CRI rating so I will make sure I get strips that have a high rating.

Peter Bucek says:

That’s really cool!

Mountainpixels says:

Very good Video
but it would be nice to have some Background Music

MisterMsk says:

Great for a room that doesn’t have good lighting.

Мохаммад says:

Well done

 Write a comment

*

Do you like our videos?
Do you want to see more like that?

Please click below to support us on Facebook!